Knowledge Base
/ Rockwell In-chassis
/ ControlLogix
/ MVI56E Series
/ MVI56E-DNPNET
How do I control Binary Outputs Using the MVI56E-DNPNET Module?
While most DNP commands are defined in the DNPNET.CONFIG.DNP_Client_Commands array, controlling binary outputs for relays etc uses Control Relay Object Block functions which are defined in DNPNET.CONTROL.CROB_Commands .
All CROB functions can use the following settings:
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Port_Flag |
20 |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Server_Address |
5 |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Object |
12 |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Variation |
1 |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Function |
5 |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Point_Number_In_Server |
(pointin server) |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Control_Code |
(see table below) |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Pulse_Count |
1 |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Pulse_On |
1 (milliseconds) |
DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Pulse_Off |
1 (milliseconds) |
However Control_Code will be specific to each CROB function:
Trip: |
2#0000_0000_1000_0000 |
Close: |
2#0000_0000_0100_0000 |
Latch ON: |
2#0000_0000_0000_0011 |
Latch OFF: |
2#0000_0000_0000_0100 |
Pulse ON: |
2#0000_0000_0000_0001 |
Pulse OFF: |
2#0000_0000_0000_0010 |
Note: With Pulse ON and Pulse OFF, the Pulse_Count, Pulse_On and Pulse_Off settings are also used.