Two-Port Building Automation Gateway
What do you need help with?
What AGA specification version is used for Flow Calculations in the ProSoft MVIxx-AFC modules?
The AGA Specifications include Part 1 "General Equations and Uncertainty Guidelines", dated 1990; Part 2 "Specification and Installation Requirements", dated 2000; Part 3 "Natural Gas Applications
Lire la suiteIn the IEC 60870-5-104 protocol, what is the purpose of the "RESET_PROCESS" command, "C_RP_NC_1"; and what does it do?
procedure to close an open socket connection. On page 45 of the protocol specification, it describes the process as: Figure 20 shows the controlling station establishing a connection by giving an Active
Lire la suiteHow do I change the name and address of the Site Operator in my Opacts/TermLinx application?
the active site as usual. (2) Menu (3) In the window that opens, click "find". (4) In the list to the left, click (highlight) the entry that represents your site (5) In the panel to the right, note
Lire la suiteWhat do the QuickServer LEDs indicate?
, but if it is a major one, it may require repair of the unit, so a Support Engineer will be needed to help determine the degree of the error. TX/RX - These LEDs are connected to the R2 serial port (the bottom serial
Lire la suiteHow do I control Binary Outputs Using the MVI56E-DNPNET Module?
) DNPNET.CONTROL.CROB_Commands.CROB_Commands[0].Pulse_Off 1 (milliseconds) However Control_Code will be specific to each CROB function: Trip: 2
Lire la suite