Two-Port Building Automation Gateway
What do you need help with?
IP Addresses not showing up in the Radio Discovery Tool
Make sure you connect to your radio with an Ethernet cable (Cat5, Cat5e, Cat6, etc) either directly or through a switch. *Radio's have auto detect port so straight-through or crossover are fine
Lire la suiteIs it possible for a FactoryTalk View application to get data from a DCSNet(2) AN-X-AMX Slave?
Yes, To do so create an ethernet device by right clicking on EtherNet:Browse the NET ENI folderBrowse the PLC5 FolderSelect the 2nd PLC5 in the list which is the PLC5 L40CWhen prompted enter the IP
Lire la suiteWhy am I getting: Download was successful but Module failed to reboot in 60 seconds
cards separating the Prosoft card and the nearest power supply. 5) Your Prosoft card's Add-On Instruction block is not aiming at the correct slot (for example, it's connection input is set to local:1:I
Lire la suiteWhich firmware should I use for a DH+ PLC to an EtherNet/IP HMI
with connecting HMIs like panel views to Remote I/O PLC and will not work in DH+ applications. If you will will be talking to a SLC5/04 with DH+ via an Ethernet Panel View, please refer to the tech note
Lire la suiteWhat driver should be used in RSLinx Classic to browse or get data from PLC5 or SLC controllers on a DH+ network?
What driver should be used in RSLinx Classic to browse or get data from PLC5 or SLC controllers on a DH+ network?
Lire la suite