Knowledge Base

Two-Port Building Automation Gateway

Catégories

What do you need help with?

How can I determine what hardware BIOS is installed on my MVI94?

Please use the following procedure: 1 - Power down the MVI94. 2 - Remove it from the base. 3 - Place the Setup jumper to short both pins, as shown in the diagram on the side of the module. 4

Lire la suite

Where can I find more information about Allen-Bradley DH-485 protocol and how to set up ProSoft DH-485 solutions on such networks?

/2181376/214372/1535907/3404063/tab3.html Please note that Rockwell recommends that every device on a DH-485 network be connected to the network via a 1747-AIC,1747-PIC, or 1761-NET-AIC device. To set up a link between a SLC 5/03's DH

Lire la suite

How to avoid slow data updates on a Modbus network with an MVI56(E)-MCM or MVI69-MCM when some Slaves are either not on-line or not functioning correctly?

.  Once the slave starts responding normally, the master will continue to poll it normally.  Skipping commands to non-responding slaves speeds up polling to slaves that do respond.   3) When a slave

Lire la suite

Where can I locate the User Manual for the MVI46-MCM

All User Manuals for Prosoft Technology products can be found on the product pages of our website, or on the CD supplied with the product. <="" user="" mvi46-mcm="" a="">   Related Keywords

Lire la suite

What's the difference between Modbus ASCII and Modbus RTU?

uses time gaps (3.5 character times) of silence for framing. The two modes are incompatible so a device configured for ASCII mode cannot communicate with one using RTU.  Modbus ASCII messages require

Lire la suite