Two-Port Building Automation Gateway
What do you need help with?
Is it possible for a FactoryTalk View application to get data from a DCSNet(2) AN-X-AMX Slave?
Yes, To do so create an ethernet device by right clicking on EtherNet:Browse the NET ENI folderBrowse the PLC5 FolderSelect the 2nd PLC5 in the list which is the PLC5 L40CWhen prompted enter the IP ... DCSNet, DCSNet2, FactoryTalk View, HMI, Shortcut, ... Is it possible for a FactoryTalk View application to get data from a DCSNet(2) AN-X-AMX Slave?
Lire la suiteWhat is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?
When using the DCSNet(2) firmware in a slave configuration the addresses use the following layout:Drop 0 = N100:0 - N100:63Drop 1 = N101:0 - N101:63Drop 2 = N102:0 - N102:63etc....The first 32 ... DCSNet, DCSNet2, AutoMax, ... What is the default addressing schema for the EtherNet IP DCSNet(2) Slave interface?
Lire la suiteHow to figure out what the IP Address of an AN-X2 gateway is?
There are 2 ways to determine the current IP Address of an AN-X2 gateway. If AnxInit is installed on the PC, then AN-X2 modules will respond to the locate all query that can be found under ... How to figure out what the IP Address of an AN-X2 gateway is?
Lire la suiteWhen operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?
When operating as a DCSNet(2) slave can the AN-X-AMX gateway be configured to emulate more than 1 drop area?
Lire la suiteWhat do the jumpers do on the PLX3x gateways?
By default the PLX3x gateway should have the jumper in a vertical position, which places the gateway into a normal operational state. Mode 2 is used to reset the gateway to the default IP Address
Lire la suite