Two-Port Building Automation Gateway
What do you need help with?
If I am reading the value from ProSoft 4x register, and it represents a digital input or digital output, how is the value stored?
Each digital point coming from the drive will be placed in an integer register in the ProSoft module. So a digital 0 will be an analog 0 (0x00), and a digital 1 will be an analog 1 (0x01).
Lire la suiteMSG instruction fails to the MVI56-BAS module
A compatibility issue exists between RSLogix version 13 and FW revision 1.03 of the MVI56-BAS. A new version of firmware has been released for the MVI56-BAS. Please contact your regional Technical
Lire la suiteI need to set up a ProSoft PROFIBUS Master to talk to a Siemens S7-300 series CPU that is set up as a PROFIBUS Slave. How do I do that?
The attached file shows how to set up a S7-315 CPU to be a PROFIBUS DP Slave to a ProSoft MVI56-PDPMV1 PROFIBUS Master and was written for that specific application. However, many of the setup steps
Lire la suiteWhat are the advantages of the MVI46-MCM compare to the 3150-MCM?
Here are some of the main advantages of the MVI46-MCM over the 3150-MCM: Direct M0/M1 file access, makes it much easier to configure You do not need to page memory as the 3150-MCM supports
Lire la suiteMy MVI46 module faults the processor after cycling power to the rack.
will automatically update any M1/M0 slot references in the logic as you drag the MVI module from one slot to another in the I/O configuration.
Lire la suite