EtherNet/IP™ to DH+ Gateway
What do you need help with?
What is the backplane current draw for MVI56, MVI56E, MVI69, MVI46 and MVI71 modules?
The backplane current draw for modules in these series is 800mA at 5.1VDC. Additionally, MVI69 modules are required to be within two slots of a power supply on the 1769 bus.
Lire la suiteHow do you detect the individual Slave failure?
that there was a problem during the command execution. The command error list can be found in the read data zone at the address you specified in mcm.port1.cmderrptr.
Lire la suiteWhat are the basic memory specs for the MVI56-ADM?
System RAM = 1MB, OS flash RAM = 1MB, application compactflash module: up to 2GB. note: the ADM module uses a version of DOS as the operating system.
Lire la suiteHow do I read/write Modbus binary data?
, use Function Code 1. To write Coil bit-level data, use Function Code 5 to write a single Coil (bit), or Function Code 15 to write multiple Coils (bits). For all ProSoft MCM solutions, be sure to use
Lire la suiteHow do I get Floating Point (or Double INT or Unsigned INT) data?
to store each 32 bit value in the internal database, it is important to remember that the next available value is not just the current address +1, but rather it would be current address +2.
Lire la suite