EtherNet/IP™ to DH+ Gateway
What do you need help with?
Connecting RS232/Channel 0 port on my V17 or V18 Logix processor to connect to my ProSoft device halts communications..
channel 0, RS232, processor, UART, serial port, DF1
Lire la suiteMy RSSI values do not seem to be accurate beyond a -60dBM signal in my RLX-IFH9E/RLXIFH24E radio. Why?
) are accurate to within a few dB. As of July 27, 2010, the latest version is 3.21/1/102. It is planned to address this issue in a future release of ControlScape.
Lire la suiteI am using a ProSoft MVI46 solution and I am getting a Fault Message that says, "Specialty I/O Module in Slot x has not responded within the time limit." What can cause this?
. If the MVI46 module continues to cause this fault, please check for the following: 1. Be sure the BATT LED is Off. If it is On Red, it can cause this fault. To correct the problem, leave the MVI46 module
Lire la suiteHow does one autostart an application in the appsrvce?
_LOCAL_MACHINEInit] "Launch10"="shell.exe" "Launch20"="device.exe" "Launch30"="gwes.exe" "Depend30"=hex:14,00 "Launch50"="taskman.exe" "Depend50"=hex:14,00, 1e,00 In the preceding example, Gwes.exe is dependent on Device
Lire la suiteHow can I detect the feedback status of individual command successful or failed?
be found in the read data zone at the address you specified in mcm.port1.cmderrptr.
Lire la suite