PCB Prior Release Version 4.4.4.4.0252
What do you need help with?
Programming an SLC 5/04 over DH+ through a ProLinx module.
Technical note from Rockwell Automation that can be used to set this up: The SLC 5/04 has a DF1 to DH+ pass thru option that can be set in the processor that will allow a DF1 connection from ... Programming an SLC 5/04 over DH+ through a ProLinx module.
Read moreMy MVI69 module is not working. What might be wrong?
and begin normal operation. 3. The MVI69 modules need 800mA of 5vdc current from the backplane. If the power supply is inadequate, the module will not function normally. 4. The MVI69 modules have a Power
Read moreWhen using the sample ladder I get an M0/M1 file reference error in my SLC processor if the MVI46 or 3150 is not in Slot 1.
is M0:1.XXXX and M1:1.XXXX If the module is in slot 5, then the file reference would be MO:G>5.xxxx and m1:5.xxxx The same slot reference applies to input and output files (i and o references)
Read moreWhy is the bit or coil level data incorrect?
function codes 1, 5, and 15), the internal address specified in the command must be at the bit level. Example: If the command is issuing a bit read (function code 1), and you wish to place the data ... Modbus Coil Commands, FC1, FC2, FC5, FC15, Modbus bit level commands, bit level addressing, coil level addressing,
Read moreWhat Flex I/O Adapters have the MVI94 Modules been tested with?
The ProSoft MVI94 modules have been tested with the following adapters and platforms: 1794-ACN15 (ControlNet) PLC5, ControlLogix, SLC 500 1794-AENT (Ethernet) 1794-AENTR (Ethernet
Read more