- Solutions
- Produits
- SERVICES ET SUPPORT
-
ACTUALITÉS
- ProSoft Insights (Blog)
-
Podcast
Featured ProductsKnowledge Base
Two-Port Building Automation Gateway
Catégories
What do you need help with?
Why am I unable to communicate with Wonderware from a 4xxx or 5xxx Series gateway in a full Duplex DF1 configuration
The Wonderware driver ABKF2 does not process or use the station ID when operating in Full Duplex mode. The DF1 full duplex specification requires a station id when more than one device is present
Lire la suiteIn the MVI56-BAS how can I transfer a string to the CLX Processor?
is transferred to the processor for i=1 to l step 2 rem all the ASCII chars are extracted value = asc($(0),i) + asc($(0),i+1) * 256 push value push int(i/2) + 202 cal l25 rem and transferred
Lire la suiteWhere are the on-board jumper positions defined for my MVI module?
On bottom of the circuit board for any MVI products, you' ll find three jumper banks: COM1, COM2, and Setup. Each jumper position is labeled 232, 422 and 485.
Lire la suiteHow many weatherproofing kits do I need for my radios?
Weatherproof, RLX, RLX2, RadioLinx, Wireless, Accessories, Kit, Radio,
Lire la suiteMy 3150-MCM block IDs are incrementing until I connect the communications cable. Once the cable is connected, the block ID stops incrementing.
Verify the cable matches the diagram on page 50 of the user manual. If pins 7 and 8 are not jumpered, and there is communications on pins 1 or 9, your backplane transfers will fail. The error status
Lire la suite