EtherNet/IP™ to DH+ Gateway
What do you need help with?
SD Card Support on the PLX31 & PLX32 Series Gateways
formatted with FAT32 should be supported. We have tested SDHC cards up to 4GB in size. 3)exFAT and NTFS are not supported. 4)Any other partition formats are more than likely not supported.
Lire la suiteWhat are common things that prevent reliable DH+ communications on the AN-X(2)-AB-DHRIO gateway running the DH+ Bridge FW?
(for 230k4 use 82 ohm resistors) 2) Ensure that at least 10' or 3 meters of cable is used between gateway and any surrounding nodes 3) Ensure that the outer braided shield has been grounded in one place
Lire la suiteWhat do the jumpers do on the PLX3x gateways?
By default the PLX3x gateway should have the jumper in a vertical position, which places the gateway into a normal operational state. Mode 2 is used to reset the gateway to the default IP Address ... What do the jumpers do on the PLX3x gateways?
Lire la suiteHow does the gateway know where to load or store configuration files (SD card or non-volatile RAM)?
When the PLX3x gateway boots it checks for an SD card. If an SD card is present it will load the configuration file stored on the SD card. If an SD card is not present than the gateway will load
Lire la suiteWhy am I getting: Download was successful but Module failed to reboot in 60 seconds
Prosoft card's Add-On Instruction is either not installed, or the rung it is on is not being completed, scheduled, or jumped to. 3) You have not yet installed the right end cap. 4) There are more then 3
Lire la suite