The Time Sync module provides Precision Time Protocol (PTP - Grand Master) and NTP Time services. This enables precision time synchronization for Logix Controllers and HMI systems. It can also provide GPS position and velocity data. The module uses an on-board GPS receiver to provide accurate time and position information.
Because the module is stand-alone and connects to various devices over an Ethernet network the module can be placed as close as possible to the antenna position removing the need for costly low-loss coaxial cables that was traditionally needed to connect the GPS antenna to the module. The on-board GPS receiver also provides velocity and odometer reading allowing the user to implement the module in various vehicle and tracking applications. The GPS accuracy information provided allows the user/controller to make calculated decision when looking at the position, velocity, or odometer information.
A built-in webserver provides detailed diagnostics of system configuration and operation, including the display of GPS time, position, and velocity without the need for any additional software.
The Slate Configuration Utility software is used for configuration and troubleshooting of the module. The stand-alone configuration utility allows users to define the setup and configuration of the Time Sync module, connections with controllers and devices.
EtherNet/IP Network
Specification |
Description |
Connector |
RJ45 |
Conductors |
CAT5 STP/UTP |
ARP Connections |
Max 20 |
TCP Connections |
Max 20 |
CIP Connections |
Max 10 |
Communication Rate |
10/100 Mbps |
Duplex Mode |
Full / Half |
Auto-MDIX Support |
Yes |
GPS
Specification |
Rating |
Antenna Port |
SMA-Female |
Supported Constellations |
GPS / QZSS, GLONASS, SBAS, BeiDou |
Velocity Accuracy |
0.05 m/s |
Heading Accuracy |
0.3 degrees |
Horizontal Position Accuracy |
2.5 m (Autonomous) 2.0 m (SBAS) |
Accuracy of Time Pulse Signal |
60 ns |
Altitude Limit |
50,000 m |
Velocity Limit |
500 m/s |
GPS Antenna
Specification |
Rating |
Antenna Connector |
SMA-Male |
Cable Length |
3 m |
Cable Type |
RG174 |
Antenna Type |
Active |
Active Gain |
27dB (Typical) |
Noise Figure |
1.5 (Maximum) |
Voltage |
2.7 to 5.5 VDC |
Temperature |
-35 to +85 °C |
1588 PTP / NTP
Specification |
Rating |
NTP support (PC time synchronization) |
Yes |
1588 PTP Grandmaster support |
Yes |
1588 PTP Management Support |
Yes |
1588 PTP End-to-End (E2E) Delay Mechanism Support |
Yes |
1588 PTP Peer-to-Peer (P2P) Delay Mechanism Support |
Yes |
1588 PTP / NTP GPS clock source support |
Yes |
1588 PTP Holdover reporting support |
Yes |
1588 PTP Network Transport |
IPv4 UDP IEEE802.3 |
Legacy Device Time Synchronization
Specification |
Rating |
Allen-Bradley PLC5 time synchronization |
Yes |
Allen-Bradley SLC time synchronization |
Yes |
Modbus Device register updating |
Yes |
Legacy Device Auto Time Zone support |
Yes |
Specification |
Rating |
Power Supply |
Input: 10 to 32 VDC, (80 mA @ 24VDC) |
Power Consumption |
1.9 W |
Dimensions (H x W x D) |
101.0 x 22.5 x 120.0 mm |
Connector |
3-way terminal |
Conductors |
24 to 18 AWG |
Enclosure Rating |
IP20, NEMA/UL Open Type |
Temperature |
-20 to 70 °C |
Humidity |
0 to 95% RH, non-condensing |
Earth Connection |
Yes, terminal based |
Emissions |
IEC61000-6-4 |
ESD Immunity |
EN 61000-4-2 |
Radiated RF Immunity |
IEC 61000-4-3 |
EFT/B Immunity |
IEC 61000-4-4 |
Surge Immunity |
IEC 61000-4-5 |
Conducted RF Immunity |
IEC 61000-4-6 |
UL/cUL; Class1, Div 2 | 238,99 kB | Dernière Modification 25/01/2024 |
ODVA Certification | 35,26 kB | Dernière Modification 28/09/2020 |
ATEX Letter of Conformity | 248,50 kB | Dernière Modification 12/05/2022 |
Korean KC Registration | 278,63 kB | Dernière Modification 09/03/2023 |
CE Declaration of Conformity (CE, UKCA, RoHS, UL) | 339,65 kB | Dernière Modification 26/01/2024 |