# IEC8704Q.CFG # # Example file for use with PTQ-104S module # # [Module] Module Name : PTQ-104S Module Type : PTQ-104S [Backplane Configuration] Module Name : PTQ-104S MODULE Failure Flag Count : 0 #Determines if BP failure will cause protocol to be #disabled (0=Ignore, >0 = failure count to disable) Error Offset : 1031 #Location of where to write status data (-1=disable) Initialize Output Data : 0 #0=No, 1=Yes read output values from controller # This section is used by the ProTalk module to define the data transferred between # the module and processor. # # Cmd Type --> 0=Disable, 1=Quantum to ProTalk, 2=ProTalk to Quantum, 3=Control # data block for module # DB Address --> address of starting word in database # Point Type --> 0=0x, 1=1x, 3=3x and 4=4x # Point Address --> point address (1 based)(0x and 1x must be at start of word (i.e., 1, 17, 33, ...)) # Word Count --> number of words to transfer (1 to 130) # [Backplane Data Exchange] # Cmd DB Point Point Word # Type Address Type Address Count START 1 0 4 1 100 #move data from Quantum to PTQ (Monitored Data) 2 100 4 101 100 #move data from PTQ to Quantum (Controlled Data) 3 500 4 501 64 #command control data area END # This section is used to define the parameters required for the Simple Network Time # Protocol (SNTP) client. [SNTP CLIENT] NTP SERVER IP ADDRESS : 132.163.4.102 #IP address for NIST, Boulder, Colorado TIME ZONE : 7 #Number of hours from GMT (-11 to +11) USE DAYLIGHT SAVINGS TIME : No #Yes or No DATABASE REGISTER : 3500 #database word location where to store time (-1=ignore). #This register value should be an even number. # This is the configuration for the IEC-870-5-104 server port emulated on the # Ethernet port on the module. # [IEC-870-5-104] # Network configuration Use IP List : 0 #Use IP list to validate connection (0=No, 1=Yes) Override StartDT : 1 #Used to ignore STARTDT/STOPDT state (0=No, 1=Yes) Clear queue on close : 0 #Clear the queue when connection closed (0=No, 1=Yes) t1 timeout set value : 60 #timeout of send or test ASDU t2 timeout set value : 10 #timeout of ack when no data (t2